Search
Issue: #3 (612)
Calculation and Design of Machinery
The Bauman MSTU — Basic organization of the CIS member states on vocational retraining and raising the level of specialists’ skill in new lines of development of engineering and technology
| Authors: Kovalchuk A.K., Gaimanov S.I. | |
Category: Calculation and Design of Machinery |
|
| Keywords: | |
The investigation of behaviour of missile aeroelastic oscillation frequencies inside the dynamic stability area under variation of individual structural components mass and stiffness
| Authors: Georgiev A.F. | |
Category: Calculation and Design of Machinery |
|
| Keywords: mass, stiffness, rocket, aeroelasticity, natural frequencies | |
Hydrodynamics of a mixing grid-intensifier, developing a convective transfer for pressurized water reactors
Strength calculation of momentum perception mechanism for the gear-and-roller planetary gearing
| Authors: Plekhanov F.I., Ovsyannikov A.V. | |
Category: Calculation and Design of Machinery |
|
| Keywords: deformation, gear-and-roller planetary gearing, internal engagement, interface, load distribution | |
Synthesis of fine-module hook toothing for one-way non-friction type eccentric mechanisms
| Authors: Sharkov O.V. | |
Category: Calculation and Design of Machinery |
|
| Keywords: one-way clutch, hook toothing | |
Transportation and Power Engineering
Systems of vehicle-borne electrical equipment with limited primary power supply
| Authors: Garmash Yu.V. | |
Category: Transportation and Power Engineering |
|
| Keywords: glass cleaning, brushes, automobile, time between movements, rate of brushes movement, vehicle safety | |
Simulation of a Stressed-Strained State of Augmented Locomotive Engine Connecting-Rods
| Authors: Chajnov N.D., Matisen A.B. | |
Category: Transportation and Power Engineering |
|
| Keywords: mathematical model, locomotive engine, connecting-rod, finite-element analysis, makroelement | |
Technology and Process Machines
The Investigation of conditions to increase the precision of geometry of surfaces processed by different grain size and standard grinding wheels
| Authors: Gusejnov G.A., Bagirov S.A. | |
Category: Technology and Process Machines |
|
| Keywords: Grinding, surface grinding, different grain size, empirical model, abrasive action, contact area, cutting force | |
The Influence of cutting modes on chips shrinkage when turning WT6 titanium alloy
| Authors: Zhilyaev S.V., Kugultinov D.S. | |
Category: Technology and Process Machines |
|
| Keywords: chip reduction coefficient, cutting mode, titanium alloys, experimental research | |
Forming a Simplified Motion Path of a Bipedal Walking Robot
| Authors: Kovalchuk A.K., Kulakov D.B., Semenov S.E. | |
Category: Technology and Process Machines |
|
| Keywords: bipedal walking robot, motion path, harmonic functions, motion control synthesis | |
The rotor system with magnetic bearings based on high-temperature superconductors (HTS)
| Authors: Polushchenko O.L., Nizhelskii N.A., Sysoev M.A. | |
Category: Technology and Process Machines |
|
| Keywords: stiffness, superconducting bearing, high-temperature superconductors, HTS, permanent magnet, load capacity | |