Search
Issue: #2 (695)
Calculation and Design of Machinery
Calculation of the Cutting Forces When Processing Plastic Materials with a Wide Range of Thicknesses of the Cutting Layer
| Authors: Grubyi S.V. | |
Category: Calculation and Design of Machinery |
|
| Keywords: chip formation parameters, shear angle, chip reduction coefficient, relative shear, cutting force, roughness parameters | |
A Numerical Study of the Dynamics of a Rotating Curved Spring Using a Single Coil as a Finite Element
The Research of Geometry and Qualitative Indicators of a Gear Pump with Internal Involute Gearing
Transportation and Power Engineering
The Estimation of Efficiency of Composite Materials in Energy-Absorbing Zones of Automotive Body Structures
Technology and Process Machines
Mechanical Properties of Woven Metal Mesh Used for Manufacturing Porous Net Materials from 12Kh18N10T Steel
| Authors: Tretyakov A.F. | |
Category: Technology and Process Machines |
|
| Keywords: porous net materials, woven metal mesh, mechanical properties, stress-strain diagram, percent reduction, pressure welding | |
Ultrasonic Welding of Caprolon B Centrifugal Pump Impellers
The Influence of New Kinematics of the Rolling Roller on the Quality of the Hardened Layer Under Surface Plastic Deformation
| Authors: Zaides S.A., Ngo Cao Cuong | |
Category: Technology and Process Machines |
|
| Keywords: two-radial roller, deformation hardening, surface plastic deformation, surface layer quality, roughness, hardness, residual stresses | |
Simulation of Contact Loads in the ANSYS Environment for Non-Involute Meshing
| Authors: Karatushin S.I., Khramova D.A., Bokuchava P.N. | |
Category: Technology and Process Machines |
|
| Keywords: contact stresses, stress-strain state, cycloid gearbox, eccentric-cycloid gearing, worm gearbox, ANSYS | |
Creating Rational Conditions for Turning Surfaces of Dissimilar Structural Materials by Brittle Superhard Cutters